+ 971 4 3333 082

KUPER ZFS

Cuts veneer packs exactly parallel and straight on two sides with a top and bottom knife.


Function KUPER ZFS System Josting

The veneer pack is placed on the machine table and up against the limit stop. The rear cutting line is clearly indicated by a guide light and the front cutting line by an optimization laser. Once the cuttingwidth is entered, the cutting cycle is executed: The table moves intocutting position, the pressure bar clamps the veneer pack in place, and the top and bottom knife cut the pack ready for jointing. When the cutting cycle is completed, the table returns to the alignment position. Veneer strips are cut only with the top knife in incremental mode.

1

High-speed positioning drive

The machine table with the bottom knife can be adjusted for various width dimensions by means of a high-speed positioning drive. First the pressure bar clamps the veneerpack, then the top knife cuts downwards towards the table and the bottom knife upwards towards the pressure bar.

 

2

Option finishingcut

Rough cut + finishing cut = Super veneer joints. No break-outs from the bottom of the veneersheets. Tighter joints with all types of veneer.

3

 

Technical Details


Special Cutting Lenthgs upon request: 

ZFS 1600 1610 mm
ZFS 2800 2810 mm
ZFS 3200 3210 mm
ZFS 3800 3810 mm

Technical Details

Insertion height 80 mm
Cutting range 20 – 470 mm*, ZFS 1600: 45 – 400 mm
Pressure bar Hydraulic cylinders, 2 pressure stages
Top knife brake motor, gearing, crank drive, ZFS 1600 hydraulic activity
Bottom knife 1 hydraulic cylinder, ZFS 1600 hydraulic activity
Operating voltage standard 400 V, 3 Ph, 50 cycl. or special voltage
Total connected load approx. 12 kVA
*upon request different range possible

 

TO FIND OUT MORE, KINDLY GET IN CONTACT WITH ONE OF OUR SALES MANAGERS.